wattzahl

  • Ersteller Ersteller suzula
  • Erstellt am Erstellt am
suzula

suzula

New Member
Beiträge
6
Ort
DE
Bassix
ß240
hi!
ich hab ne frage.
ich hab nen 600watt mesa boogie amp.
wie is das mit den wattzahlen?
ich hab vor mir 4 2x10 zu kaufen. welche wattzahlen müssen die dann haben, dass ich je nach bedarf 1,2 oder alle 4 dranhängen kann?

vielen dank schon mal

suzula
 

Der M-Pulse 600 kann bis 2 Ohm belastet werden.
Mesa empfiehlt jedoch auf 4 Ohm zu bleiben.

2. The optimum speaker load for your M-PULSE is 4 Ohms. You may use a cabinet (s) of a higher rating safely (8 Ohm) with no
degradation in tone, however the amplifier will not produce its full rated wattage. Minimum load rating is 2 Ohms and while the MPULSE
will handle this lower load condition - and in fact produce more than its rated power, it is not recommended. Prolonged use
of a 2 Ohm load will cause the power mosfets to run hot causing the protection circuit to trigger and mute the output signal until such
time as the mosfets can return to a safe operating temperature. Avoid using 2 Ohm loads whenever possible.

Das heißt in deinem Fall, du brauchst 4 Boxen á 16 Ohm.
Dann kannst du jeweils 2 Boxen zusammen oder alle 4 benutzen.

Eine Box würde ich mit einem Impedanzwandler austatten, damit du sie auch alleine (in einer vernünpftigen Lautstärke) nutzen kannst.
 
hey vielen dank, dass war ja mal fixe antworten!
danke
 

Beliebte Themen

Zurück
Oben Unten